Quick Reference Guide

Control Panel Messages (Continued)
Control Panel Messages (Continued)
9
Message Light Explanation Response
PAPER JAM Paper Out light Paper has jammed in the
flashing printer.
PAPER NOT STRAIGHT Paper Out light on Paper was fed at an angle.
SERVICE REQ. All lights flashing An error has occurred.
<error number>
TURN PWR OFF AND This message appears after
ON you clear a paper jam.
Error messages (Continued)
Pull the paper set lever all the
way out and open the lower
cover if necessary. Then remove
the jammed paper, close the
lower cover, and push the lever
in. Turn the printer off and then
back on.
Reload paper, making sure the
edges are straight and lined up
with the rows of holes.
Note the error number, and turn
the printer off and then on. If the
message remains, contact
EPSON.
Turn the printer off and then on
again.
Where To Get Help
Where To Get Help
EPSON and EPSON Stylus are registered trademarks of SEIKO EPSON CORPORATION. EPSON UltraChrome, EPSON Archival, and
EPSON Photographic Dye are trademarks and EPSON Preferred is a service mark of Epson America, Inc.
Copyright © 2002 by Epson America, Inc. 8/02
Service
Telephone support
World Wide Web
Support for non-EPSON RIP
Place your EPSON Preferred
SM
Unit ID label here
Access
Call [phone]. Make sure
you have your Unit ID number.
If you experience any difficulty with the toll-free number or your Unit ID
number, call [phone].
Go to http: //support.epson.com to download drivers, access product
documentation and troubleshooting, and get technical advice
through e-mail.
Contact the RIP manufacturer.
SP10600 QRG 9/16/02, 05:11 PM9