Continuous Ink Supply System for EPSON Stylus CX4200 Installation Instruction For XM Prefilled Version With Auto Reset Chips This Version of the Continuous Ink Flow System comes with Prefilled Cartridges and Auto Reset Chips. You just need to fill the Reservoir bottles and print! The whole operation is very easy. It’s really an effective tool to save your money.
CIS for EPSON Stylus CX4200 Instruction Thank you for purchasing XM Continuous Ink Supply System. We appreciate your support and will try our best to make your experience with our products a pleasant one. Printing has been a different experience ever since you installed XM Continuous Ink Supply system on your own printer. Just imagining being able to print without regard to the ink level in those expensive little cartridges. Please take your time installing XM Continuous Ink Supply system.
Put the CISS on the left side of the printer. In the meantime place all the tubes at correct position. Pull out the small rubber plug from the air hole as above picture shown. Place 4pcs of air filters into air holes, the thicker side is down into tank. 2、Second step: Remove the Cartridge A B c 1) Press the “ink cartridge replace button” (Picture A) on the printer to move the cartridge to the cartridge remove position (Pic.B) 2) Unplug the power connector at the back of the printer (Pic.C) 3、Step 3.
、Step 4. 1)Remove old cartridges in the printer (Pic A); 2) Insert the CIS cartridges into the cartridge car (Pic B); Make sure the cartridges installed well.(Pic.C) A B C 5、Step 5, Fix Supporting Arm: 1) Tear off the sticker(Pic A); Measure 2.6cm from the edge of the printer, Attach supporting arm on the printer as Picture B show; 2) The right position like Picture C shown 3) Tear off the sticker of small tube clamp;Attach it at the 4cm away from the edge of the Printer. As picture F shown.
7、Step Seven: Adjusting the Tube Adjust the tube length and move the cartridge car. Insure there will no block and collision when the tubes moving with cartridge car .Insure there's plenty length of tube to make the cartridge cart can thoroughly move to the left side. The tube is excessive long, it is not ok. The tube is twist ,it is not ok. In this situation ,it is ok 8、Step Eight: Install the clamp like the Picture Shown(Pic A),Plug the power connector (Pic.A) ; Turn on the power (Pic B).
9、Ninth step: Checking the Printing head Printing Head Normal Printing testing normal,Begin to print Printing Head printing Break Printing Break ,Clear the printer head Enter Printer service If there shows any breaks (maybe it caused by air bubbles in the printing head), please clean your printing head. If it is still shown little breaks, especially only for one color, it is unnecessary to repeatedly clean printer-head.
the rubber plugs from the refill holes.(there is possibility of ink spattering. Be careful!) Refill ink according to the color in short supply. Then put the rubber back. (Please keep the printer and the reservoir at the same horizontal line during the process of refilling ink.) Close the cartridge cover as the below pictures shown. Attention for maintenance: Take out the CISS including the inner cartridges and other components. Then remove support arm from printer, and place the original cartridges in.