Laptop User Manual

If you see one of the following errors, there may be a problem

with the controller or the test cable:

Error - Break detected

Error - Framing error

Error - Overrun error

Error

- Parity error

Error -

Time out!

Check to make sure that the test connector is securely

connected to the port. If the error persists, contact your dealer.

Exiting System Diagnostics

To exit from the System diagnostics program, press

[Eecl.

You

see the following prompt:

Do you want to exit diag (Y/N)? N

Before you press a key, remove the Reference diskette from

drive A. If you do not have a hard disk, insert

our system

diskette in the drive. Then press

[VI

and

to exit the

program. You see this message:

Stand by while system is rebooting.

The computer loads the operating system.

Performing System Diagnostics

B-25