User Guide Desktop PC Equity 386SX/16 PLUS

Align the connector with the socket so the tab on the

connector lines up with the notch in the socket. Make

sure the holes in the connector fit over all the pins in the

socket and then push in the connector.

Caution

If you do not correctly align the holes with the pins,

you could severely damage your computer when you

push in the connector.

Now connect the hard disk drive cable in the same

manner.

To replace the front panel, fit the three ridged tabs on its

bottom edge into the three notches on the lower edge of

the

computer, as shown below.

tabs

Tilt up the front panel until the clips on the top of the

panel touch the computer. Then push on the top of the

panel until it clicks into place.

10. Follow the steps on page 5-40 to replace the computer’s

cover. Then see “Post-installation Setup” on page 5-42 for

instructions on configuring your computer.

Installing and Removing Options

5-39