User Guide Desktop PC Equity 386SX/16 PLUS

5. As you lower the drive into the vertical mounting area,
guide the ribbon cable underneath the drive.
hole
- tabs in slots
As shown above, fit the tabs on the mounting plate into
the slots on the side of the subassembly. Then tilt the
drive toward the subassembly and align the retaining
screw hole on the mounting plate with the hole in the
bracket.
6. Secure the drive to the bracket with the retaining screw.
If you used the instructions above to install your drive while
the subassembly is out of the computer, see “Replacing the
Subassembly” on page B-46. Do not follow the steps in the
next section.
Installing and Removing Disk Drives B-17