User Guide Desktop PC Equity 386SX/16 PLUS

Removing the Subassembly
Follow these steps to remove the subassembly:
1. Turn the computer so that the front panel is facing you.
2. To remove the front panel, lift up slightly on the three
clips at the top of the panel and tilt it toward you, as
shown below. Then pull the panel away from the front of
the computer.
clips
If you are going to install a hard disk drive in the lower
horizontal position, set the front panel aside and go to
step 4.
If you are installing a diskette drive, remove the slot
cover from the front panel, as described in step 3.
B-28
Installing and Removing Disk Drives