User Guide Desktop PC Equity 386SX/16 PLUS

Locate the four retaining screws that came with your disk

drive, Insert two screws into the oval holes on each side

of the drive bay and tighten them with a screwdriver, as

shown below.

screws

If you are installing a diskette drive, go to step 5. If you

are installing a hard disk drive, go to step 6.

If you are installing a diskette drive in the lower drive

bay, you may want to turn the subassembly upside down

and place it on your work surface. Then locate the

diskette drive ribbon cable; one end is connected to the

top diskette drive and the other end is free. Use the

connector in the middle of the cable to connect the

second drive.

As shown in the next illustration, there is a large slot in

this connector with a small plastic divider near one end

of the slot,

Installing and Removing Disk Drives

B-35