User Guide Desktop PC Equity 386SX/16 PLUS

Grasp the disk drive from the front of the drive bay, pull

it completely out, and set it aside.

If you have removed one hard disk drive and are leaving

another one in your system, make sure you have set the

jumpers on the remaining drive to indicate that you now

have only one hard disk drive. (If not, see “Setting the

Hard Disk Drive Jumpers” on page B-4 for instructions.)

If you do not need to replace a hard disk drive in the

vertical mounting position, see “Replacing the

Subassembly” below.

If you need to reinstall a hard disk drive in the vertical

mounting position, follow the steps under “Installing the

Drive” on page B-12. However, it is easier to replace the

drive while the subassembly is out of the computer.

Follow the steps in that section as if the subassembly was

installed. Then see “Replacing the Subassembly,” below.

Installing and Removing Disk Drives

B-45