User Guide Desktop PC Equity 386SX/16 PLUS

10. To replace the front panel, fit the three ridged tabs on its
bottom edge into the three notches on the lower edge of
the computer, as shown below.
tabs
11. Tilt up the front panel until the clips on the top of the
panel touch the computer. Then push on the top of the
panel until it clicks into place. The diskette drive(s)
should be flush with the front panel.
(If you removed the slot cover, be sure to store it in a safe
place in case you need to replace it later.)
12. Follow the steps on page 5-40 to replace the computer’s
cover. Then see “Post-installation Setup” on page 5-42
for instructions on configuring your computer for use
with your new disk drive configuration.
B-54 Installing and Removing Disk Drives