User Setup Information

Connecting the Scanner to the Computer
Follow the steps below to connect the scanner to your
computer’s SCSI interface using the cable included with the
scanner.
1. Turn off your computer, scanner, and any other peripheral
devices.
Caution:
Be sure that your computer, scanner, md any other
peripheral devices are turned off before you plug in the
ccrble.
2. Connect one end of the SCSI cable to either the top or bottom
SCSI connector on the scanner; then fasten the connector
with the wire clamps on its side, as shown.
3. Connect the other end of the SCSI cable to the connector on
the SCSI interface card you installed in the computer.
Fasten the connector with the wire clamps.