Specifications

ES300C SCANNER
Tabk S.~igitd~a@ning sctttngs
a-2 2-l Set DIgItal lMtonlng
OFF OFF Bl-kd
OFFON Hal6onsA
CU OFF HatlMsB
ON ON HdttoneC
Table 6. Gamma corwction
Table 7. Color corraztion
2-7 2-6
Set Color Correodon
OFF OFF lmpactdotpdnter
OFF ON Thermalprlrrtsr
ON OFF Inkjetprlnter
ON ON Monltor(CRT)
The optional units available for the ESBOOC eca~er ere:
. Bidirectional interface board for IBM PC and compatibles
l EpScanII
scanner utility program
l Apple Macintosh SCSI interface kit board
l EpScsn Mac ecanner program
Pin Assignments (Serial)
Pm No. SlgnalNw UD DsadpUon
1 FG - Fnme gmund
2 lxD
0 Tnnsmltdata
3
FIXD I RscBhdata
I I
6 10 19
NC(IWwd 1
20
DTR 0 Date temtkml ready
21 to 25
NC Not usml
Pin Assignments (Parallel)
Slgnal
Owcrlptbn
-STROBE pubs to read In or send out data. Pubs
wklth at recelvii termkml must excesd 0.5
micmsscontls.
These SIgnSIS Convey the 1st to 8th bits of data. HQh
level indkates ~lcal 1; bw level lndlcatss bgbal0.
Pubs of approximately 12 mb-rids. Low level
ldcates thst data has been recetved and the
scanner ls ready to accept more data.
When this slgnal Is high. the scanner cannot mcetve
dsta. The SlQnSl be~mc#i high duflng data entry.
during scsnnlng. witen the scunwr Is not ready. and
during scanner enor.
Not usad
Loglc gmund lsvel
Scanner chsssls ground
Not ussd
-STROBE
20-27
DATA g-7
-ACKNLG
12-15
t
16 GND
GGND
NC
Return
Pln No. Pin
Slgnal II0 Descrlptlon
1430 - GND -
Twstwir return signal ground level
31 - INIT
I
Whsn mb &pal level becomes bw. the
reset 10 ItS poweron State. Thb bvel Is usually
The pubs wMth at ttm mceivmg tennlnal must bs
greater than 50 mb-rub.
32 -
NC Notused
33 - GND - Twisied-psir mtum signal ground bvel
3435 - NC Not ussd
36 - DIR
I
Low irxtlcates that climc%bn Is Input.
ES-300C-4
Scanners