Service manual

Document # 720000-0000
May 2008
26
EZ LOAD PRINTER
Service
Manual
6.6 Instruction F: Removal of printing mechanism
1. Remove top cover by following instruction A
2. Disconnect all printing mechanism harnesses
3. Open door and remove three (3) screws which are holding roller part of mechanism, as
shown in Figure 24 using tool 1
Figure 24: Printing mechanism 1
4. Remove screw which is holding main part of mechanism, as shown in Figure 25 using
tool 2
Figure 25: Printing mechanism 2
5. Lift up, releasing mechanism from the two (2) lances as shown in
Figure 26
Figure 26: Printing mechanism 3