Service manual

Document # 720000-0000
May 2008
27
EZ LOAD PRINTER
Service
Manual
6.7 Instruction G: Removal of the paper low sensor
1. Remove top cover by following instruction A
2. Disconnect paper low harnesses
3. Remove two (2) screws as shown in Figure 27 using tool 2
Figure 27: paper low sensor 1
1. Separate sensor from sensor plate by remove screws as shown in Figure 28 using tool 2
Figure 28: paper low sensor 2
6.8 Instruction H: Removal of the door
1. While holding nut with tool 3, remove screw with tool 2 (x2)
Figure 29: Door