Service manual

Document # 720000-0000
May 2008
28
EZ LOAD PRINTER
Service
Manual
6.9 Instruction I: Removal of MetriMate I/O harness (optional item)
1. disconnect power and remove db9 connector
2. While holding nut tool 3, remove screw using tool 2
3. remove grounding harness by removing screw using tool 2
Figure 30: MetriMate harness
6.10 Instruction J: Removal of power supply (optional item)
1. Follow Instruction A, D & E
2. Remove two (2) screws as shown in Figure 31 using tool 2
Figure 31: Power supply