Declaration of Conformity

Para los usuarios de México
Este equipo contiene el módulo inalámbrico siguiente:
Modelo (Módulo): J26H005
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es
posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este
equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
We: EPSON AMERICA, INC.
Located at: 3131 Katella Ave.
Los Alamitos, CA 90720
Telephone: [phone]
Declare under sole responsibility that the product identied herein,
complies with 47CFR Part 2 and 15 of the FCC rules as a Class B
digital device. Each product marketed, is identical to the
representative unit tested and found to be compliant with the
standards. Records maintained continue to reect the equipment
being produced can be expected to be within the variation accepted,
due to quantity production and testing on a statistical basis as
required by 47CFR §2.906 Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Trade Name: EPSON
Type of Product: Thermal Printer
Model: M382A/M382C
Supplier’s Declaration of Conformity
According to 47CFR, Part 2 and 15 for Class B Personal Computers and Peripherals;
and/or CPU Boards and Power Supplies used with Class B Personal Computers:
For Users in Northern America
FCC Compliance Statement for Users in the USA
is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. ese limits are designed to
provide reasonable protection against harmful interference in a residential installation.
is equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC/I4&% Compliance Statement
FCC CAUTION
Changes or modications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This device complies with part 15 of FCC Rules and *OOPWBUJPO4DJFODFBOE&DPOPNJD%FWFMPQNFOU Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme à la partie 15 des règles de la FCC et aux normes des CNR d’IOOPWBUJPO4DJFODFTFU%ÏWFMPQQNFOUÏDPOPNJRVF Canada applicables
aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’appareil doit accepter tout brouillage subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
e available scientic evidence does not show that any health problems are associated with using low power wireless devices. ere is no proof, however, that these low
power wireless devices are absolutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas
high levels of RF can produce health eects (by heating tissue), exposure of low-level RF that does not produce heating eects causes no known adverse health eects.
Many studies of low-level RF exposures have not found any biological eects. Some studies have suggested that some biological eects might occur, but such ndings
have not been confirmed by additional research.
TM-P80II (M382A/M382C) has been tested and found to comply with FCC/I4&% radiation exposure limits set forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines and RSS-102 of the I4&% radio frequency (RF) Exposure rules.
Les connaissances scientiques dont nous disposons n’ont mis en évidence aucun problème de santé associé à l’usage des appareils sans l à faible puissance. Nous ne
sommes cependant pas en mesure de prouver que ces appareils sans l à faible puissance sont entièrement sans danger. Les appareils sans l à faible puissance émettent
une énergie fréquence radioélectrique (RF) très faible dans le spectre des microondes lorsqu’ils sont utilisés. Alors qu’une dose élevée de RF peut avoir des eets sur
la santé (en chauant les tissus), l’exposition à de faibles RF qui ne produisent pas de chaleur n’a pas de mauvais eets connus sur la santé. De nombreuses études ont
été menées sur les expositions aux RF faibles et n’ ont découvert aucun eet biologique. Certaines études ont suggéré qu’il pouvait y avoir certains eets biologiques,
mais ces résultats n’ont pas été conrmés par des recherches supplémentaires. TM-P80II (M382A/M382C) a été testé et jugé conforme aux limites d’exposition aux
rayonnements énoncées pour un environnement non contrôlé et respecte les règles les radioélectriques (RF) de la FCC lignes directrices d’exposition et d’exposition aux
fréquences radioélectriques (RF) CNR-102 de l’I4&%.
*OOPWBUJPO4DJFODFBOE&DPOPNJD%FWFMPQNFOU$BOBEB*4&%/PUJDFT
5IFEFWJDFGPSPQFSBUJPOJOUIFCBOEo.)[JTGPSJOEPPSVTFPOMZ
-FTEJTQPTJUJGTGPODUJPOOBOUEBOTMBCBOEFEFB.)[TPOU1PVSVTBHFJOUFSJFVSTFVMNFOU
Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these
radars could cause interference and/or damage to LE-LAN devices.
Les utilisateurs devraient aussi etre avises, d’une part, que les utilisateurs de radars de haute puissance sont designes utilisateurs principaux (c.-a-d., qu’ils ont la priorite) des
bandes de 5 250 a 5 350 MHz et de 5 650 a 5 850 MHz et, d’autre part, que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs de RL-EL.
© S
eiko Epson Corporation 2022.
Printed in ::::::
Wi-Fi
®
is a registered trademark of Wi-Fi Alliance
®
.