Specifications

5-16
5-16 | Maintaining and Transporting the Printer
5. Press
Enter
. You see
SELECT INK SET
.
The printer gives you two choices for the new set of black ink cartridges,
depending on which ones are already installed (press
u
or
d
to see the
choices). For example, if you’re currently in Photo Black Mode and you
want to change to Matte Black Mode, you’ll switch only the first
cartridge to Matte Black, leaving the Light Black cartridge in place. (The
printer indicates this option with
#1 MAT: #2 LBK
.) If you want to
switch to Dual Matte Black Mode, you’ll have to replace both cartridges
with Matte Black. (The printer indicates this option with
#1 MAT:
#2 MAT
.)
6. Make sure you know which cartridges you want to install, then press
u
or
d until the correct set of cartridges is displayed.
7. Press
ENTER
.
If you see the message
NOT ENOUGH INK
, lift the ink lever and
remove any low or empty cartridges. (Check the
Ink Out
lights on the
control panel to see which cartridges are low or empty.) Insert the
replacement cartridge(s), then lower the ink lever.
8. The printer displays a message telling you to release the ink lever and
remove the cartridges. Raise the lever and remove all the cartridges; do
not re-insert them until instructed to do so.
Be sure to set aside any black ink cartridges you won’t be using, so that
you don’t accidentally re-insert them.
Caution
Do not turn off the printer
once the cartridges are
removed.
If a power failure occurs,
turn the printer back on.
You can resume the
procedure at the point
where it was interrupted.
Printer Guide.book Page 16 Monday, April 22, 2002 3:02 PM