Specifications

1-36
1-36 | Setting Up the Printer
6. If you’re connecting with a parallel cable or network interface card, see
the note at left. Otherwise, follow the instructions below for your
operating system.
Windows 95 or NT: Turn on your printer and go to step 7.
Windows 98, Me, or 2000: When you see a window asking you to turn
on your printer, press the
P
Power
button. Then go to step 7.
Windows XP:
•
When you see a window asking you to turn on your printer, press
the
P
Power
button.
•
If you see a message that your printer is not connected properly,
ignore it (do not click
Retry
or
Cancel
). If necessary, drag the
window to the side.
•
Wait until you see the Found New Hardware Wizard for the Stylus
Pro 7600 or 9600. This may take a minute or two.
•
Once the Found New Hardware Wizard appears, click
Install from
a list or specific location
, then click
Next
.
•
Locate the
Drivers\Win2K_XP
folder on your CD-ROM drive, as
shown below. Then click
Next
.
7. When you see a message informing you that installation is complete,
click
OK
or
Finish
. If asked to do so, restart your computer.
8. If any screens remain open or continue to open, close them to exit.
Note
If you’re connecting with
a parallel cable or
Ethernet card, do not turn
on your printer when you
see a window telling you
to do so. Instead, wait
until the Stop Searching
button appears. Then
click the button and go to
step 7.
When installation is
complete, the port
setting defaults to LPT1
(parallel port). If you’re
using an Ethernet card,
you’ll have to reconfigure
the port setting. See your
electronic Reference
Guide for details.
Printer Guide.book Page 36 Monday, April 22, 2002 3:02 PM