User's Manual

n o Draft
f o Draft Condensed
n n Roman
f n Roman Condensed
n f Sans Serif
f f Sans Serif Condensed
n
=On,
f
=Flashing,
o
=Off
4. Make sure that the font you want is selected, and then press
the
Pause
button to exit the font selection mode.
Making Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting
from the printer’s control panel using the default-setting mode.
For a detailed description of the settings you can change in the
default-setting mode, see the following section. For instructions
on changing the settings, see “Changing default settings” later
in this chapter.
Understanding default settings
This section describes the settings and options available in the
default-setting mode. These settings are divided into two
groups, shown in the tables on pages 5-4 and 5-8. The settings
are explained in detail after each table.
To access and change a setting, note the group (1 or 2) it is in,
check its description in the next pages for more information,
then see the section on changing default settings at the end of
this chapter.
5
R
Gentian-W Rev.C
A5 size Chapter 5
11/14/97 pass 0
Changing Printer Settings From the Printer’s Control Panel 5-3