User's Manual

Default-setting mode 1
Setting Options
Skip over perforation Off, On
Auto tear-off Off, On
Auto line feed Off, On
Print direction Bi-D, Uni-D
Software ESC/P, IBM 2380 Plus for FX-880,
IBM 2381 Plus for FX-1180
I/F (interface) mode Auto, Parallel, Optional
Auto I/F (interface) wait time 10 seconds, 30 seconds
0 slash 0, 0
High speed draft Off, On(10 cpi), On(12 cpi)
Input buffer Off, On
Buzzer Off, On
Auto CR (carriage return)* Off, On
IBM character table* Table 2, Table1
* This setting is available only in IBM 2380/2381 Plus emulation mode
(IBM 2380 Plus for FX-880, IBM 2381 Plus for FX-1180).
Skip over perforation
This feature is available only when continuous paper is
selected. When you turn on this feature, the printer provides a
one-inch (25.4 mm) margin between the last line printed on one
page and the first line printed on the next page. Because most
application program margin settings override margin settings
from the control panel, you should use this setting only if you
cannot set your top and bottom margins using your application.
L
Gentian-W Rev.C
A5 size Chapter 5
11/14/97 pass 0
5-4 Changing Printer Settings From the Printer’s Control Panel