Addendum

Changing Modes

To enter Okidata mode, make sure the printer is turned off. Then hold

down the Tear Off/Bin and Pause buttons while you turn on the

printer. The printer beeps once to indicate it is now in Okidata mode.

The printer remains in Okidata mode until you repeat the above

procedure. To return to FX-880+ mode, hold down the Tear Off/Bin

and Pause buttons while you turn on the printer. The printer beeps

twice and is now operating in FX-880+ mode.

Note: When you switch from one mode to the other, any changes you made

to the printer’s settings in the original mode are restored to their default

values. You can print the default settings for the printer when it is in

Okidata mode to check the current settings and change them if necessary. See

“Changing Default Settings” in Chapter 3 of your EPSON FX-880+/

FX-1180+ User’s Guide.

system, or transmitted in any form or by any means, electronic, mechanical, photocopying,

recording, or otherwise, without the prior written permission of SEIKO EPSON

CORPORATION. The information contained herein is designed only for use with this

EPSON printer. EPSON is not responsible for any use of this information as applied to

other printers.

Trademarks

EPSON and EPSON ESC/P are registered trademarks of SEIKO EPSON CORPORATION.

General Notice: Other product names used herein are for identification purposes only and

may be trademarks of their respective owners. EPSON disclaims any and all rights in those

marks.

11/01