User`s guide

Fine-Tuning the Projector 51

■ Tracking

Adjust this value to eliminate vertical stripes in computer

images.

■ Sync

Adjust this value if computer images appear blurry or flicker.

■ Position

If the image is slightly cut off on one or more sides, it may not

be centered exactly. Select this setting and use the pointer

button to center it.

■ Progressive

For composite video, S-video, and component video signals

only. Turn this setting on to convert interlaced signals into

progressive signals (best for still images). Select

Video for

viewing general video images. Select

Film/Auto for movie

images, CG, and animated images. Leave the setting

Off for

moving images.

■ Noise Reduction

Smooths out rough images. Select your favorite setting.

Epson recommends that you select

Off when viewing image

sources with very low noise, such as DVDs.

■ Input Signal

If the colors don’t look right on the Auto setting, select the

setting for the type of equipment you’ve connected to the

Computer1 or Computer2 ports. Choose RGB for a

computer or RGB-video connection, and

Component for a

video player that outputs a component video signal (with

connectors labeled Y/Cb/Cr or Y/Pb/Pr).

note

You can also use the remote

control’s

Auto button to

automatically reset the

rojector’s Tracking, Sync,

and Position settings. See

age 89 for details.

note

The Noise Reduction setting

cannot be set for digital

RGB signals.