User`s guide

60 Fine-Tuning the Projector
■ Operation
Enable Direct Power On if you want to be able to start the
projector when you connect the power cord (without pressing the
Ppower button). Enable Sleep Mode if you want the projector
to turn off automatically if it is idle (and no signal is received) for
10 minutes (you can adjust the amount of time using the
Sleep
Mode Timer setting). Enable High Altitude Mode when you are
using the projector above 4,900 feet (1,500 meters).
■ Standby Mode
Select Network On to enable monitoring of the projector over a
network when it is in standby mode (the power light is orange).
■ Projector ID
Lets you assign a numeric ID to each projector. When you are
using multiple projectors, you can use the ID to select the one you
want to operate with the remote control. See page 43 for
instructions.
■ Multi-screen
Use this option if you want to color-match two or more projectors
that are being used to display images near each other. You can
make image adjustments at each of five adjustment levels. First
choose an
Adjustment Level and then adjust the settings for
each level:
Brightness Correct to adjust the brightness, and
Color Correct to adjust the balance between red and green, or
blue and yellow. See page 61 for more information about
multi-screen color adjustment.
■ Language
Select from 27 languages to be used for the projector menus.
note
If a power outage occurs
when Direct Power On is
enabled and the power cord
is connected, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).