User`s guide

Maintaining the Projector 75
You may also need to replace the lamp if the Lamp light flashes
red. See page 83.
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L47.
Follow these steps to replace the lamp:
1. Turn off the projector and, after the projector beeps twice, unplug
the power cord.
2. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
3. Loosen the lamp cover screws (you don’t need to remove them).
Then remove the lamp cover.
Lamp light
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury. If the projector has
been installed on the ceiling,
you should stand to the side
of the lamp cover, not
underneath it.
If the lamp is used after the
replacement period has
passed, the possibility that
the lamp may break
increases. When a lamp
replacement message
appears, replace the lamp
with a new one as soon as
possible, even if it is still
working.
note
Even when the lamp cover is
removed, it is still attached
to the projector to prevent it
from falling when the
projector is mounted on the
ceiling.