Operation Manual

Plugging in the Scanner

1. Connect the power cable to the power inlet on the rear of the

scanner and plug the other end into a properly grounded

outlet as shown below.

Caution:

There are several versions of this scanner designed for

different voltages, and it is not possible to change the

voltage. If the label on the back of the scanner does not

show the correct voltage for your country, contact your

dealer.

2. If any of the scanner’s lights come on, press the

OPERATE

button to turn the scanner off.

Caution:

Whenever you turn off the scanner, wait at least 10

seconds before turning it back on. Rapidly turning it on

and off can damage the scanner.

1-2

1-3

Ginger Rev.C

A5 size Chapter 1

97/07/23 Pass 1, DR

1-4

Setting Up the Scanner