Operation Manual

Connecting the scanner to your computer or another SCSI

device

Connect the scanner as follows:

1. Make sure that the scanner, the computer, and all other SCSI

devices are turned off and unplugged from the power

source.

2. Connect the 50-pin end of the cable to either the top or

bottom SCSI connector of the scanner; then squeeze the

wire clips together until they lock in place on both sides.

3. Connect the other end of the cable to the SCSI port of your

computer or another SCSI device.

Note:

❑

The SCSI port of the Macintosh is the larger port with the

SCSI icon over it.

❑

If you are connecting the scanner to a SCSI device other than

the computer, use a cable with 50-pin connectors on both

ends.

4. Connect the power cables of your computer, scanner, and

other external SCSI devices.

5. Always turn on the scanner and other external SCSI devices

before you turn on your computer.

1-8

Ginger Rev.C

A5 size Chapter 1

97/07/23 Pass 1, DR

Setting Up the Scanner

1-11