Operation Manual

Removing the shipping screw
To prevent damage during shipping, a shipping screw is
attached to the Transparency Unit. Remove this screw before
you attempt to use the Transparency Unit.
1. Turn the unit so the glass side faces up.
2. Remove both shipping screws as shown below.
3. Secure the screws you just removed in the storage holes
towards the center of the scanner, as shown below.
c
Caution:
If either screw is left in an outer hole while using the
Transparency Unit, the unit may be damaged.
04-07
04-08
R
Ginger Rev.C
A5 size Chapter 3
97/07/23 Pass 3, DR
Options
3-3