Operation Manual

Loading documents manually
You can load documents manually even when the Auto
Document Feeder is installed.
To load a document manually, lift the Auto Document Feeder
and place the document on the document table. Then lower the
Automatic Document Feeder and scan the document as
described on page 2-4.
Note:
❑
Opening the Auto Document Feeder while scanning is in
progress will result in an option error and may result in a paper
feeding error.
❑
Always close the Auto Document Feeder before scanning or
using the feeder.
Scanning from the Auto Document Feeder
The scanning instructions are divided into two sections; read
“Scanning an entire image” to scan an entire document or
image, or read “Scanning only part of an image” to scan only a
certain part of an image or document.
Scanning an entire image
You do not need to use the preview feature when scanning a
full document or image. The scanner automatically finds and
scans the whole image. Follow the steps below to scan an
image or document.
1. Load paper in the Auto Document Feeder as described on
page 3-22.
2. Start the PageManager software and select
Acquire
from
the File menu.
L
Ginger Rev.C
A5 size Chapter 3
97/07/23 Pass 3, DR
3-24
Options