Operation Manual

Initialization Methods
The scanner can be initialized (returned to a fixed set of conditions) in the
following ways:
Hardware initialization
*
The scanner is turned on.
*
The scanner receives an INIT signal from the
parallel interface: pin 31 goes LOW.
*
The scanner receives a SCSI Reset signal
from the SCSI interface.
Software initialization
*
Software sends the ESC @ (initialize the
scanner) command.
*
The scanner receives a SCSI Bus Device
Message.
R
Ginger Rev.C
A5 size Appendix A
97/07/23 Pass 0, DR
Technical Specifications
A-7