User's Guide

Display message Condition/solution
Check battery The batteries may be running out or installed incorrectly, non-alkaline
batteries are installed with alkaline batteries, or old and new batteries are
Change alkaline
installed together. Turn the power off and replace batteries with new ones, or
use the AC adapter. Make sure new batteries are installed correctly.
Too many lines You have exceeded the maximum number of lines. Delete the lines
indicated.
No more sequence No. ! The label already has sequence numbers. You can only enter one sequence
per label.
Text is too long.
Entered text is too long for the specified label length. Press to confirm and
Continue?
continue printing. The printer will automatically adjust the label length.
Insert 24 mm tape! The label design can only be printed on 1-inch (24 mm) wide tape.
Load wider tape Unable to print on the current tape. Use a wider tape.
Printing length too long! Shorten the label text.
No more barcode! You can only add one barcode to a label when you are using the built-in
keyboard.
QR CODE too big! Do one of the following: use a wider tape, reduce the text or cell size, or
lower the ECC (Error Checking and Correction) level.
Overheated! The print head is too hot. Turn the power off and take out the tape cartridge.
Allow the print head to cool before trying to print again.
Cover open! Powering If you open the rear cover while the power is on, this message displays and
off. the power turns off automatically. Always turn the power off before opening
the rear cover.
Motor error! An error occurred in the motor operation. Turn the power off, then turn it back
on. If the same message appears, turn the power off again and contact
Epson for technical support.
Parent topic: Solving Problems
Related references
Where to Get Help
Related tasks
Inserting and Removing Tape Cartridges
Installing Batteries
115