User`s manual

Replace the paper tension unit as shown below. Tilt the unit

back and position the back notches on the unit over the rear

mounting pins of the printer. Press the levers open as you tilt the

unit toward you until the front latches click in place over the

front mounting pins located behind the paper bail.

Attach the paper guide cover to the printer cover as shown

below. Then install the printer cover unit onto the printer.

Set DIP switch 1-7 to OFF to turn off the cut sheet feeder mode.

Note: When DIP switch l-7 is OFF, the printer uses the

continuous paper page length selected by DIP switches 2-l and

2-2.

5-26

Using the Printer Options