User`s manual

Problem
Solution
Printed characters
are not what you
expected
(continued).
The printer prints a
series of strange
characters.
The print position is
not what you
expected.
Printing starts too high
or too low on the page.
Text is printed on the
same line.
Text is printed with an
extra blank line in
between.
Your printer and the computer may not
be communicating correctly. Make sure
that you are using the correct interface
cable and that the communication
protocol is correct. See your computer’s
manual for more information.
Make sure the interface cable is fastened
securely to both the printer and the
computer.
The loading position may be incorrect.
Use micro-adjustment to adjust the
loading position. See Chapter 3. If the
problem persists, check the top margin
set by your application software and
adjust it.
A line feed signal is not being sent at the
end of each line of text. Change the auto
line feed setting with DIP switch 2-8. See
Chapter 3.
Two line feed signals are probably being
sent. Change the auto line feed setting
with DIP switch 2-8. See Chapter 3.
Troubleshooting 7-11