User`s manual

Problem
Solution
Switching between
single sheets and
continuous paper
cannot be
performed properly
(continued).
The paper release lever
is correctly set for
continuous paper, but
when the LOAD/EJECT
button is pressed, the
platen rofates
backward and the
paper comes off the
sprockets.
When the LOAD/EJECT
button is pressed to
load a single sheet from
the paper guide, the
platen rotates in
reverse, the single sheet
does not load, and the
continuous paper
comes off the sprockets.
A single sheet may be in the paper guide,
causing the continuous paper to back out
and to come off the sprockets. When
using continuous paper, always make
sure to remove any single sheets
remaining in the paper guide. See
Chapter 2.
The paper release lever may not be in the
proper position. Push the lever back to
the single-sheet position, set the paper,
then press the LOAD/EJECT button.
Troubleshooting 7-25