User`s manual

Problem
Solution
Using the cut sheet
feeder, the paper
does not feed
properly
(continued).
One page of printing
has spread to two
pages.
When printing
The two front levers may not be set to
envelopes, the
envelope feeding. Push down on the two
envelopes either do not
front levers until they lock into position.
feed or feed incorrectly. See Chapter 5.
Using the pull
tractor with the
push tractor,
continuous paper
does not feed
properly.
The FORM FEED or
LINE FEED button was
pressed, but the paper
does not feed at all.
(Platen does not
rotate.)
The printer may be on line. Before using
the control panel buttons to feed paper,
always take the printer off line (ON LINE
light out).
The page length setting may be wrong.
Run a self test in cut sheet feeder mode.
The printer will automatically measure
the paper loaded and set the correct page
length. See Chapter 5.
You may have to change the top or
bottom margin or page length for your
application program.
Troubleshooting 7-31