User`s manual
Problem
Solution
Using the pull
tractor with the
push tractor,
continuous paper
does not feed
properly
(continued).
Paper feed is crooked or
the paper jams
(continued).
Several lines of space
occur in the printout.
Skip over perforation is
set, but it does not
work.
The paper may be slack. Adjust the
position of the sprockets to take up any
slack along the width of the paper.
Remove slack lengthwise by pressing in
and rotating the pull tractor knob on the
right. Do not turn the platen knob.
The paper thickness lever may not be
correctly set. Set the paper thickness lever
to match the thickness of your paper.
The paper may not meet the
specifications. Check that your paper is
the proper size, weight, and thickness.
Skip over perforation may be set. Set DIP
switch 1-8 to off.
You may have changed the DIP switches
with the power on. To make new DIP
switch settings effective, turn the power
off, then on again.
Troubleshooting
7-33