User`s manual

ESC(-
Select Score
Format:
ASCII code:
ESC ( - nl n2 m
dl d2
Decimal:
27 40 45 nl n2 m
dl d2
Hexadecimal: 1B
28 2D nl n2 m
dl d2
Comments:
Use decimal or hexadecimal values for all variables, not ASCII
characters.
Use the following values for the first 3 variables:
nl must be 3.
n2 must be 0.
mmustbel.
The value of d1 determines the location of the score:
d1 = 1 for underline.
d1 = 2 for strike-through.
d1 = 3 for overscore.
The value of d2 determines whether the score line is single,
double, broken, or continuous:
d2 = 0 Cancel the score line selected by d1.
d2 = 1 Single continuous line.
d2 = 2 Double continuous line.
d2 = 5 Single broken line.
d2 = 6 Double broken line.
The last three bits of d2 determine the characteristics of the score
line as shown below:
On (1)
Off (0)
Bit 2
Bit 1
Broken line
Double line on
Continuous line Double line off
Bit 0
Single line on
Single line off
Note: If bit 1 and bit 0 are both off, the selected score is
canceled. Double line and single line scores cannot be
combined at the same score position.
Command Summary 9-31