Operation Manual

3
LW-K400 User’s Guide
Before use
1. Preparing the power supply
This product operates on batteries or with the dedicated AC adapter.
Using on batteries
c
Prepare six AA alkaline batteries.
1. Remove the cover on the rear.
2. Insert the batteries.
MEMO
When continuing to install a tape cartridge, leave the cover o and
go to Step 2.
3. Close the cover. Close it until it snaps into place.
Using with the AC adapter (APT0615Z)
c
Make sure to use the dedicated AC adapter (APT0615Z).
1. Connect the AC adapter rmly into the power socket of the
product.
2. Plug the AC adapter into the outlet.
2. Installing a tape cartridge
1. Remove the slack of the ink ribbon.
2. Remove the cover on the rear.
3. Set the tape cartridge.
Press it rmly until it snaps into place.
When installing a new tape or the tip of the tape is longer than
usual, put the tape through the "Tape Guide" slot.
c
• Do not press the "Cut Button" before the tape stops.
• Do not pull the tape out with your ngers.
4. Close the cover on the rear.
Close it until it snaps into place.
How to remove the tape cartridge
c
Hold the cartridge by the tabs, and lift it straight up.
3. Turning the power on
1. Press .
When changing the language of messages on the display
sDisplay Settings ("Display" menu)
4. Feeding the tape
c
Do not press the "Cut Button" before the tape stops.
After setting a tape cartridge, make sure to feed tape.
1. Press
+ .
2. Press
.
3. Cut the tape.
Cut it by pressing the "Cut Button".
5. Creating a label
Example: ABC
1. Press
while holding down to enter text in capital letters.
2. Press the following keys:
, ,
"ABC" appears on the display.
Refer below for other operations and the labels you can create with
this product.
sEditing characters, Useful functions, Creating a label with a
special form