Unit installation

In each tractor slot are two pegs that fit into the notches on the
tractor fittings. Tilt the tractor back so that the rear notches fit over
the rear pegs. Then tilt the unit forward until it clicks into place. That’s
all there is to it.
Now install the paper separator and pull out the paper guide as
shown in Figure D-4.
Fit the notches in the bottom corners of the separator over the pins
at the front of the paper slot. The separator keeps the paper that is
coming out of the printer from being pulled back in. Pull out the paper
guide at the back of the printer.
Figure D-4. Paper separator and paper guide
When you want to use single sheet paper in your HomeWriter-10,
you can remove the tractor unit quite easily. Just push back the two
tractor release levers shown in Figure D-5, tilt the unit backwards, and
lift it up.
D-3