Unit installation

Figure D-5. Tractor release levers
Loading Continuous Paper
Once your tractor is installed, you can load continuous paper. See
that the printer is turned off, and open the front lid. Then move the
print head to the center of the printer, and pull the paper bail away
from the platen (the black roller) just as you did for single sheet load-
ing. (Look at the HomeWriter-10 Setup Instructions if you need to
check on the names of any of these parts.)
Now, using Figure D-6 as your guide, pull the locking levers for-
ward so that you can move the pin feed holders to the left and right.
Put the left holder approximately 3/4 of an inch from the extreme left
position and then push the locking lever back to lock that holder in
place. Leave the other holder unlocked.
D-4