Product specifications

8 – 1
8. PAPER FEED SPECIFICATIONS
8.1 Paper Feed Methods/Paths
When the friction feed method is used, the paper must be fed from rear.
ML3320 ML3321
(a) Friction feed (Top path) For cut-sheet paper only For cut-sheet paper only
(b) Push tractor feed (Rear path) For continuous forms For continuous forms
(c) Push-pull-traction paper feed (option) For continuous forms For continuous forms
(d) Pull tractor feed (Bottom path) (option) For continuous forms For continuous forms
(e) Bottom push tractor feed (option) For continuous forms For continuous forms
8.2 Paper Positioning Restrictions
8.3 Paper Tear-off
The paper can be torn off 0.42 inch above the first printed line. A sharp serrated edge is provided
on the access cover for paper tear-off.
8.4 Automatic Sheet Loading
With top paper feed, cut-sheets can be automatically loaded by setting paper at the top feed
position.
8.5 Paper End Detection
(1) With rear paper feed, the paper end is detected when the remaining paper length is about
1 inch (25.4 mm) from the last printed line.
(2) With bottom paper feed, the paper end is detected when the remaining paper length is
about 1 inch (25.4 mm) from the last printed line.
(3) Upon detecting the paper end, the printer stops printing and sends a paper end signal
to the interface.
(4) A paper end override function is available to allow printing to be performed line-by-line
under operator control after the paper end has been detected. (rear, and bottom)
(Friction feed) (Push-pull tractor feed )
0.35 inch (8.9 mm) or more 0.35 inch (8.9 mm) or more
Printing position on the first dot