Owner`s manual

`
Document # 103357-0004R
October, 2008
6
ULTRA SYSTEM
OWNER
’
s Manua
l
1.4.2 Function Buttons
Figure 6: Function buttons
• Function Button 1 (RED or SW500):
o Pressing while In Run Mode (“PO” on display):
Will causes the printer or terminal
to display/print a summary of the current DIP switch settings, the unit serial
number and the software revision number.
o Pressing and holding for 15 sec while powering up
: Will enable communication
with a keyboard via PS2 port
• Function Button 2 (WHITE or SW501):
o Pressing while In Run Mode (“PO” on display):
will do nothing
o Pressing and holding for 10 sec while powering up
: will do nothing
• Function Button 3 (BLACK or SW502):
o Pressing while In Run Mode (“PO” on display): Will do nothing
o Pressing and holding for 15 sec while powering up: Will put the Ultra board into
COIN IN/CASHOUT auto calibration mode. If successful, the letters “CA”
will be
seen on the display. Simply insert $1.00 to the game, then clear the credits (by
pressing the knock off or cash out button), repeat this operation for each
additional game/port which needs to be calibrated. Once finished calibrating
desired ports, press F1 (RED button) to exit (a setup report will be printed). Then
power OFF and ON the Ultra board to get back into polling mode. To reset all
ports back to the Dip Switch default values, press F2 (White Button) at any time
while in calibration mode.