Owner`s manual

Document # 103357-0004R

October, 2008

ULTRA SYSTEM

OWNER

’

s Manua

2.2 Buttons used in Combination:

• SOFT METERS + BUTTON 1: Pressing these 2 buttons simultaneously will print the

last cashout printed.

Note: The words “DUPLICATE VOUCHER” will also be printed at two locations on the

ticket.

• SOFT METERS + BUTTON 6: Pressing these 2 buttons together will clear the soft

meter values back to zero.

•

Setting a password on the SOFT METERS:

A password is set by turning the key while the soft meter button is pressed. As

confirmation, all the LEDs should turn off. Then select your password by pressing the

buttons (1-6) in the order desired, the LED of each key pressed will turn on once it has

registered. The maximum password length is 8 digits. Once desired password has

been entered, press the SOFT METERS again to save the value.

Note:

All instructions including the password itself will be printed

Note

: If no keys are pressed within 15 seconds while entering the password, the

operation will timeout.

Once a password has been set, the user will be prompted to enter the password every

time the soft meter button is activated

2.3 Meters:

The Ultra Board maintains 3 full sets of (non-volatile) electronic meters: Soft Meters, Key

Meters and Central Meters. Each set is completely independent from each other. They can be

individually cleared at any time.

• The Soft Meters

These meters are typically used by the “location owner”. To print this set of meters,

press the “Soft Meter” button. To clear the values back to zero, press the “Soft Meter”

button and button “6” simultaneously.

• The Key Meters

These meters are typically used by the “route operator”. To print the key meters, turn the

key. The key meters report will be printed immediately and will ALWAYS be cleared

following the report.

• The Central Meters

These meters are used by the remote access Nanoptix Central System software. Only

the Central System Software is capable of clearing these meters. They can also be

viewed also with the Ultra Board Configure Software, but they cannot be cleared.