Service manual

Epson AcuLaser CX-11N/AcuLaser CX-11NF Field Repair Guide 9/9/05
Printer Component, Software Item, LCD Display, Printer Button Page 14.
Support Mode
Support Mode enables access to the following settings via the Setup function:
• LCD Panel Backlight control (ON/OFF/AUTO)
• Print Density Adjustment based on media type/thickness
• Feed Offset - The vertical position at which to start printing
• Scan Offset - The horizontal position at which to start printing
To enable Support Mode:
1. While depressing the Down Arrow button, power the CX-11on.
2. Keep the Down Arrow button depressed until “SUPPORT MODE” is displayed in the upper left corner of the
LCD Panel.
Changing the LCD Panel Backlight Setting
1. Enable Support Mode by depressing the Down Arrow button while powering the CX-11 on. Keep the Down
Arrow button depressed until “SUPPORT MODE” is displayed in the upper left corner of the LCD Panel.
2. Depress the Setup button on the Control Panel.
3. Depress the Right Arrow button.
4. If Printer Settings is not highlighted, depress the Up Arrow or Down Arrow button until Printer
Settings is highlighted.
5. Depress the Right Arrow button.
6. Depress the Up Arrow or Down Arrow button until Support Menu is highlighted.
7. Depress the Right Arrow button. The LCD Panel will display the current LCD Backlight setting.
8. Depress the Right Arrow button.
9. If Printer Settings is not highlighted, depress the Up Arrow or Down Arrow button until the desired
setting is highlighted.
10. Depress the Right Arrow button to store the setting, the Left Arrow button to cancel the operation, or the
Setup button to use the new setting until the unit is reset or powered off.
manuals4you.commanuals4you.com