Service manual

Epson AcuLaser CX-11N/AcuLaser CX-11NF Field Repair Guide 9/9/05
Printer Component, Software Item, LCD Display, Printer Button Page 17.
Maintenance Mode
Detailed information regarding the Maintenance Mode is located in the AcuLaser CX11/CX11F Service Manual
Chapter 6, Section 6.4.
Maintenance Mode Menu Items
• Engine Status Sheet - prints the counted values of each unit which makes up the printer engine.
• Print Log Report - prints a log file of the pages printed by size, print mode (color or monochrome), and
coverage.
• Reset 2nd BTR Counter
• Reset C Developer Counter
• Reset M Developer Counter
• Reset Y Developer Counter
• Reset K Developer Counter
• Reset Fuser Counter
• Clear Error Log - Clears the Error Log that is printed on the Engine Status Sheet.
• MCU Data Backup - Backs up most of the EEPROM data.
• MCU Data Restore - Restores EEPROM data that was saved via MCU Data Backup.
To enter Maintenance Mode:
1. Depress the Up Arrow , Down Arrow , Left Arrow , and Right Arrow buttons simultaneously
while powering the CX-11 on. Keep the Arrow buttons depressed until “Maintenance Mode” is displayed in the
upper left corner of the LCD Panel.
2. Depress the Setup button on the Control Panel.
3. Depress the Right Arrow button.
4. If Printer Settings is not highlighted, depress the Up Arrow or Down Arrow button until Printer
Settings is highlighted.
5. Depress the Right Arrow button.
6. Depress the Up Arrow or Down Arrow button until Maintenance Menu is highlighted.