Operation Manual

18 Getting Started

Charging the battery

After installing the battery, charge the battery using

the AC adapter.

Note:

The battery status is always displayed at the top right corner

of the LCD.

1. Make sure that the battery is installed.

Caution:

Do not connect the AC adapter when the battery is

not installed. Doing so may cause P-2000 to be

damaged.

2. Connect the AC adapter to P-2000 as shown below

and plug the other end into a power outlet.

The Charge lamp is on during charging. When the

battery is fully charged, the Charge lamp turns off. It

takes about 3 hours to fully charge the battery when

P-2000 is off. It takes more when you are operating it.

Note:

P-2000 stops charging, if the battery becomes hot when

operating it during charging. In that case, it starts charging

again when it cools down.

: Indicates sufficient battery power.

: Indicates moderate battery power.

: Indicates low battery power.

: Indicates battery power is running out. P-2000 is shut down

automatically. Charge the battery using the AC adapter.

: Indicates the AC adapter is connected to P-2000.