User's Manual

Installing Software and Connecting
9-8
NOTE
If you’re sharing a serial port that you use for another device,
make sure AppleTalk

is turned off. Your Macintosh may not
recognize the camera if AppleTalk is on. If you have
problems connecting to the printer port, try connecting to
the modem port instead.
4
Open the connector cover on the side of the camera.
Carefully insert the connector on the other end of the
cable into the camera’s serial interface port.
NOTE
To disconnect the cable from the camera, squeeze and hold
the connector lock button on the side of the connector while
you pull the cable out.
5
Turn on the camera and turn the camera dial to , then
turn on your Macintosh system.
On a PowerPC or PowerMac G3, you may be able to
transfer your pictures at the rate of 230.4KB per second. If
your camera software doesn’t set this speed automatically,
you can set it manually. See your Macintosh documentation
for instructions.
Connecting the Camera with the USB Cable
You can connect the camera to your USB-enabled
Windows 98, Windows 2000, or Macintosh system using
the USB cable that came with your camera.
connector lock
button
Capella.book Page 8 Thursday, April 20, 2000 4:21 PM