Operation Manual

Capturing Video Clips and Special Shots 3-3
Continuous Shooting
In this mode, you can capture motion in a series of shots.
You can capture up to the following numbers of continuous
shots per sequence: forty-seven standard images (two per
second), thirteen fine images (two per second), or seven
super fine images (one per second).
You can’t use the flash for continuous shooting, so make sure
you have adequate lighting for your pictures. Also, you can’t
select the HyPict JPEG or uncompressed Tiff image quality
settings.
NOTE
If you want to adjust any camera settings, such as white balance,
sensitivity, or macro mode, turn the camera dial to to see the
View menu and adjust the settings. See Chapters 4 and 5 for
details.
To take a sequence of pictures:
1
Turn the camera dial to . Wait until the photo
capture light stops flashing and remains a steady green.
2
Press the button under
MODE CHANGE
to change to
Continuous Shooting mode.
You see a preview of your
picture with a red frame
around the LCD screen.
CONTINUOUS
appears
on the screen.
3
Frame your subject.
4
Press and hold the shutter button all the way down.
If the camera’s shutter sound is enabled, the camera
clicks as it captures each picture. (See page 7-3 to enable
camera sounds.)
5
When the camera has captured a sequence of pictures,
release the shutter button.
NOTE
If you continue to hold down the shutter button after the first
sequence of pictures, the camera will pause to process the
images and then take a second sequence. The camera will
continue to take pictures until the memory card is full.
