Service manual

PhotoPC 3100Z Revision A
Disassembly and Assembly Overview 62
4.1 Overview
This section describes procedures for disassembling the main components of the
product. Unless otherwise specified, disassembly units or components can be
reassembled by reversing the disassembly procedure. Things, if not strictly observed,
that could result in injury or loss of life are described under the heading “Warning”.
Precautions for any disassembly or assembly procedures are described under the
heading “CAUTION”. Chips for disassembling procedures are described under the
heading “CHECK POINT”.
If the assembling procedure is different from the reversed procedure of the
disassembling, the procedure is described under the heading “REASSEMBLY”.
Any adjustments required after disassembling the units are described under the heading
“ADJUSTMENT REQUIRED”. When you have to remove any units or parts that are
not described in this chapter, refer to the exploded diagrams in the appendix.
Read precautions described in the next section before starting.
4.1.1 Precautions
See the precautions given under the handling “WARNING” and “CAUTION” in the
following column when disassembling or assembling the product.
W A R N I N G

Remove the batteries and plug off the AC adapter before
disassembling the camera. In case of necessity to
measure the voltage, however, pay a sufficient attention
to avoid an electric shock by following the procedures
in this manual.

Whenever to disassemble the camera, make sure to
wear gloves.

When a lithium battery is installed on the main board of
this camera, make sure to observe the following
instructions when serving the battery:
1.Keep the battery away from any metal or other batteries so that
electrodes of the opposite polarity do not come in contact with
each other.
2.Do not heat the battery or put it near fire.
3.Do not solder on any part of the battery. (Doing so may result in
leakage of electrolyte from the battery, burning or explosion. The
leakage may affect other devices close to the battery.)
4.Do not charge the battery. (An explosion may be generated inside
the battery, and cause burning or explosion.)
5.Do not dismantle the battery. (The gas inside the battery may hurt
your throat. Leakage, burning or explosion may also be resulted.)
6.Do not install the battery in the wrong direction. (This may cause
burning or explosion.)

Danger of explosion if the battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacture. Dispose the used
batteries according to government’s law and
regulations.