User's Manual

4-10

Using the LCD Menus to Change Settings

Continuous Shooting

In this mode, you can take two standard or fine

resolution pictures each second, with up to ten pictures in

sequence (or one super fine resolution picture per second,

with up to eight pictures in sequence). You can capture a

complex motion, such as a golf swing, in a series of steps to

create animation sequences for the Internet, screen savers, or

presentations. Continuous shooting is available for all user

modes.

NOTE

You can’t use the flash for continuous shooting, so make sure

you have adequate lighting for your pictures. In addition, you can’t

select the HyPict image quality setting.

Make sure you are at least 20 inches (50 cm) away from

your subject.

Open the lens cover, then turn the camera dial to

Wait until the camera status light turns green.

You see a preview of your picture on the LCD screen,

with a red frame around it.

CONTINUOUS appears on

the screen.

Center your subject in the red frame.

Press and hold the shutter button all the way down. The

camera beeps as it captures each picture.

When the camera has captured the first sequence of

pictures, it stops beeping and the camera status light

flashes. Release the shutter button.

NOTE

If you continue to hold down the shutter button after the first

sequence of pictures, the camera will take a second sequence.

The camera will continue to take pictures until the memory card

is full.

Altair.book Page 10 Thursday, July 1, 1999 3:33 PM