User manual
Table Of Contents
- Contents
- PictureMate User’s Guide
- Getting to Know Your PictureMate
- Loading Paper
- Printing From Your Computer
- Printing Photos Using Film Factory
- Copying Photos to Your Computer
- Saving Your Photos to an External CD-R/RW, Zip, or Flash Memory Drive
- Storing and Displaying Your Printed Photos
- Printing Without a Computer
- Compatible Memory Cards
- Photo Image File Requirements
- Inserting Your Memory Card
- Printing a Proof Sheet from the PictureMate Print Wizard
- Printing All Your Photos From the PictureMate Print Wizard
- Printing Some of Your Photos From the PictureMate Print Wizard
- Viewing the PictureMate Main Menu
- Selecting the Photos You Want to Print
- Setting the Number of Copies in the Main Menu
- Choosing a Layout
- Confirming and Printing
- Doing More With Your Prints
- Adjusting Printer Settings
- Printing From a PictBridge-enabled Digital Camera
- Printing From an External CD, Zip Disk, or Flash Memory Drive
- Printing Wirelessly From a Bluetooth Device
- Replacing the Photo Cartridge
- Taking PictureMate With You
- Cleaning PictureMate
- Improving Print Quality
- Solving Problems
- Where To Get Help
- Uninstalling PictureMate Software
- Setting Up Network Printing
- System Requirements
- Important Safety Instructions
- Specifications
- Notices
73
6. Carefully pull out the cartridge and dispose of it properly.
Warning: Keep ink cartridges out of the reach of children and do not drink the ink.
If ink gets on your hands, wash them thoroughly with soap and water. If ink gets
in your eyes, flush them thoroughly with water. If discomfort or vision problems
continue after flushing, see a doctor immediately.
Inserting the New Photo Cartridge
1. Shake the cartridge four or five times while it is still in its package. Then unwrap
the cartridge.
Caution: Don’t touch the circuit board. Install the photo cartridge immediately
after you remove it from its package. If you leave a cartridge unpacked for a long
time before using it, normal printing may not be possible.
2. Make sure the lever is in the Release position.