User manual
Table Of Contents
- Contents
- PictureMate User’s Guide
- Getting to Know Your PictureMate
- Loading Paper
- Printing From Your Computer
- Printing Photos Using Film Factory
- Copying Photos to Your Computer
- Saving Your Photos to an External CD-R/RW, Zip, or Flash Memory Drive
- Storing and Displaying Your Printed Photos
- Printing Without a Computer
- Compatible Memory Cards
- Photo Image File Requirements
- Inserting Your Memory Card
- Printing a Proof Sheet from the PictureMate Print Wizard
- Printing All Your Photos From the PictureMate Print Wizard
- Printing Some of Your Photos From the PictureMate Print Wizard
- Viewing the PictureMate Main Menu
- Selecting the Photos You Want to Print
- Setting the Number of Copies in the Main Menu
- Choosing a Layout
- Confirming and Printing
- Doing More With Your Prints
- Adjusting Printer Settings
- Printing From a PictBridge-enabled Digital Camera
- Printing From an External CD, Zip Disk, or Flash Memory Drive
- Printing Wirelessly From a Bluetooth Device
- Replacing the Photo Cartridge
- Taking PictureMate With You
- Cleaning PictureMate
- Improving Print Quality
- Solving Problems
- Where To Get Help
- Uninstalling PictureMate Software
- Setting Up Network Printing
- System Requirements
- Important Safety Instructions
- Specifications
- Notices
79
2. Press or to highlight Maintenance, then press OK.
3. Press or to highlight
Clean Print Head, then press OK.
4. When you see this message, press OK to begin cleaning the print head.
The cleaning takes about 40 seconds, during which the message Cleaning print
head. Please wait
. appears on the screen and PictureMate makes some noise.
Caution: Never turn off PictureMate while it is cleaning its print head, unless it
hasn’t moved or made noise for more than 5 minutes.
5. When cleaning is complete, you see a message asking if you want to print a nozzle
check pattern. If you want to check to see if the nozzles are clean, load a sheet of
photo paper (see Loading Paper), then press OK to print the nozzle check.
If you don’t want to print a nozzle check, press
Cancel to go back to the
PictureMate Main Menu.
6. Check the pattern to see if there are any gaps in the lines.
Each staggered line should be solid, with no gaps, as shown.